ante
Haus und Garten GmbH & Co. KG | Im Inkerfeld 1, D-59969 Bromskirchen-Somplar | Germany
T49 (0) 29 84/308-250 | T49 (0) 29 84/308-500 | www.ante-holz.de - [email protected] | 5. Juli 2016
7
Bikeport Typ 1
204 x 202 cm Art.-Nr. 60193001
Warning:
After both side sections have been erected, position the entire construction by diagonal supports. Align the carport from the front to the back with a 1% slope (see plan
drawing on the last page).
Now it is possible to pour the concrete footings. Smooth the surface of the footings to gently slope outwards. This allows for better drainage of rainwater.
Place the rafters on the girders as shown in the drawing and connect them using the angle brackets (on alternating sides of each rafter). Install the diagonal
supports transversely on every post (see plan drawing on the last page).
Roof panels
After all of the rafters have been attached, install the roof panels. Make sure to install the panels from the back to the front. First distribute the roof panels
on the rafters so that they fit across the breadth and then over the length of the carport. It is essential to distribute and align all of the panels before
screwing down the panels!
Attach every roof panel using at least 4 spacers and screws per rafter.
Warning:
only walk on the panels using planks to distribute the weight.
It is necessary to observe the information provided on the first page.
Fascia boards
Begin with the front fascia board. Install the front fascia board to project by 2cm beyond the rafters on both the left and right sides.
Attach the fascia boards on the sides using Phillips-head screws in the ends of the rafters (please pre-drill).
The fascia boards should project beyond the roof panels by 0.5cm.
1
2
3
4
5
Step 1:
Drill through the roof panel at a slow speed using
a 10mm wood drill bit. Make sure that the drill is
horizontal and centred. Drilling at an unsuitable
speed can break the panel.
Step 2:
Place the plastic spacer in the hole. Place the
screw bit directly in the spacer to drive it through
the panel.
Step 3:
Verify the correct positioning of the spacer. The
roof panel must be resting on the spacer.
Step 4:
Now securely screw the roof panel to the rafter.
Make sure to drive the screw straight through the
panel.
Otherwise leakage may occur.
Step 5:
Do not over-tighten the screw, as this may damage
the roof panel.
