Antari 80378, Руководство пользователя, Страница: 24 / 28

23
Ordercode: 80378
Antari S-500 Snow Machine
DMX Channels
2 Channels
Channel 1 – Snow effect
0–5
Snow OFF
6–255 Snow ON: 1–100 %
Channel 2 – Fan speed
0–5
Fan speed: 20 %
6–255 Fan speed: 21–100 %
Maintenance
The S-500 requires almost no maintenance. However, you should keep the unit clean. Disconnect the
mains power supply and then wipe the cover with a damp cloth. Do not use alcohol or solvents. Do not
immerse in liquid.
Keep connections clean. Disconnect electric power, and then wipe the connections with a damp cloth.
Make sure connections are thoroughly dry before linking equipment or supplying electric power.
Remove dust from the air vents with an air compressor, vacuum or a soft brush (excessive dust, liquid and
dirt built up will degrade performance and may cause overheating). Run the machine on monthly basis
in order to achieve best performance and output condition.
Do not allow the snow liquid to become contaminated. Always close the snow liquid tank immediately
after adding the snow liquid to the tank.
Performance Note:
● Snow machines develop condensation around the output nozzle. Because this may result in moisture
accumulation on the surface below the output nozzle, consider this condensation when installing
your machine. Snow machines may occasionally sputter small amounts of snow, during operation
and/or after being turned off.
● Only use the recommended snow liquids.
Cleaning
Before storing the S-500, it needs to be cleaned.
01)
Remove the snow liquid from the snow liquid tank.
02) Add water to the snow liquid tank.
03) When the display shows READY TO SNOW, press the DOWN(VOLUME) button to start snowing.
See 2. Volume Mode on page 19 for more information.
04) After 2 minutes, press the STOP button to stop snowing.
05) Unplug the device.
06) Remove the remaining water from the snow liquid tank.
Replacing the Fuse
You do not have to replace the fuse on this device as the fuse is automatic.
01)
In case of a power surge, short-circuit or inappropriate power supply, press the circuit breaker (06)
and the device will function normally.
02) Try to determine the cause of the problem, so that the situation does not happen in the future.