Antari 80374, Руководство пользователя, Страница: 11 / 20

10
Product code: 80374
Antari AF-5E DMX Fan
Control Mode
The devices are individually addressed on a data-link and connected to the controller.
The devices respond to the DMX signal from the controller. (When you select the DMX address and save
it, the controller will display the saved DMX address next time.)
DMX Addressing
The DIP switches allow you to assign DMX device addresses, which is the first channel with which the AF-
5E will respond to the controller.
Please note when you use the controller, the device has 1 channel.
When using multiple AF-5E devices, make sure that you set the DMX addresses right.
Therefore, the DMX address of the first AF-5E should be 1(001); the DMX address of the second AF-5E
should be 1+1=2 (002); the DMX address of the third AF-5E should be 2+1=3 (003), etc.
Please, make sure that you do not have any overlapping channels in order to control each AF-5E
correctly. If two or more AF-5E devices are addressed similarly, they will work similarly.
Controlling:
After having addressed all AF-5E devices, you may now start operating these via your lighting controller.
Note: After switching on, the AF-5E will automatically detect whether DMX-512 data is received or not.
If it does not, the problem may be:
●
The XLR cable from the controller is not connected to the input of the AF-5E.
● The controller is switched off or defective, the cable or connector is detective, or the signal wires are
swapped in the input connector.
Note: It is necessary to insert an XLR termination plug (with 120 Ohm) in the last device in order to ensure
proper transmission on the DMX data link.
Main Menu Options
1. Manual Mode
01)
Plug the Schuko cable (08) into the appropriate 240 V AC power supply.
02) Make sure that DMX is not active. If DMX is active, Manual mode will not work.
03) Turn the speed selector (07) in order to set the desired fan speed. The adjustment range is between 0
(OFF) and 1–3 (from low to high speed).
04) After use, turn the speed selector (07) to 0, to switch the AF-5E off.
05) Unplug the Schuko cable (08).