Antaira Technologies
– Industrial Modbus Gateway
STM-60XC(-T) Series Hardware Manual V1.1
12
3. Mounting Installation
3.1 DIN-Rail Mounting
The DIN-Rail mount option is the quickest installation option. Additionally, it optimizes the use of rail
space. The metal DIN-Rail kit is secured to the rear of the serial device server. The device can be
mounted onto a standard 35mm (1.37”) x 75mm (3”) height DIN-Rail. The devices can be mounted
vertically or horizontally. Refer to the following guidelines for further information.
Installing the DIN-Rail Mounting Kit
1.
Insert the top back of the mounting bracket over the DIN-Rail.
2.
Push the bottom of the server towards the DIN-Rail until it snaps into place.
Removing the DIN-Rail Mounting Kit
1.
Push the server down to free the bottom of the plate from the DIN-Rail.
2.
Rotate the bottom of the device towards you and away from the DIN-Rail.
3.
Once the bottom is clear of the DIN-Rail, lift the device straight up to unhook it from
the DIN-Rail.
3.2 Wall Mounting
The wall mounting option provides better shock and vibration resistance than the DIN rail
vertical mount.
Note!
When installing, make sure to allow for enough space to properly install the
cabling.
Before the device can be mounted on a wall, you will need to remove the DIN- R ail
plate.
1.
Rotate the device to the rear side and locate the DIN mounting plate.
2.
Remove the screws securing the DIN mounting plate to the rear panel of the
server.
3.
Remove the DIN mounting plate. Store the DIN mounting plate and provided
Figure 3.1
Insert the Modbus Gateway on the DIN-Rail
Figure 3.2
Stabilize the Modbus Gateway on the DIN-Rail
