Antaira Technologies - Industrial Wireless Access Points
ARS-7235-5E-AC Series - Hardware Manual - v1.0
Figure 3.1 - Rear View of the Switch and DIN-Rail
Figure 3.2 - Insert the Switch on the DIN-Rail
Figure 3.3 - Stable the Switch on the DIN-Rail
3.2 Wall Mounting
Follow the steps below to mount the industrial wireless access point using the wall mounting bracket as
shown below in
Figure 3.4
.
Caution:
“Wall” means industrial control panel wall
Attention:
“Wall” signifie mur de panneau de commande industriel
1. Remove the DIN-Rail bracket from the industrial wireless access point by loosening the screws.
2. Place the wall mounting brackets on the top and bottom of the industrial wireless access point.
3. Use the screws to screw the wall mounting bracket on the industrial wireless access point.
Caution:
The torque for tightening the screws on the device is 3.5 in-lbs.
Attention:
Le couple de serrage des vis sur l'appareil est de 3.5 pouces-livres.
4. Use the hook holes at the corners of the wall mounting bracket to hang the industrial wireless
access point on the wall.
12
