Antaira Technologies - Industrial Wireless Access Points
ARS-7235-5E-AC Series - Hardware Manual - v1.0
3 Mounting Installation
3.1 DIN-Rail Mounting
The DIN-Rail is pre-installed on the industrial wireless access point from the factory. If the DIN-Rail is not
on the industrial wireless access point, please see
Figure 3.1
to learn how to install the DIN-Rail on the
wireless access point.
Follow the steps below to learn how to hang the industrial wireless access point:
1. Use the screws to install the DIN-Rail bracket on the rear side of the industrial wireless access
point.
Caution:
The torque for tightening the screws on the device is 3.5 in-lbs.
Attention:
Le couple de serrage des vis sur l'appareil est de 3.5 pouces-livres.
2. To remove the DIN-Rail bracket, do the opposite from step 1.
3. After the DIN-Rail bracket is installed on the rear side of the wireless access point, insert
the top of the DIN- Rail on to the track as shown below in
Figure 3.2
.
4. Lightly pull down the bracket onto the rail as shown below in
Figure 3.3
.
5. Check if the bracket is mounted tightly on the rail.
6. To remove the industrial wireless access point from the rail, do the opposite from the above
steps.
11