5
PRODUCT DESCRIPTION
The
xBase Multi
charger is suitable for charging most NiCd and NiMH batteries packs with 4-10 cells in the R/C field. All 6 outputs can be used
individually or at the same time and in parallel.
INDEX
Function
Parameter
Action
Input voltage
230 V 50 Hz
green LED lights
Output 1 to 5
Battery correctly connected
green LED lights
Output 1 to 5
Battery connected with wrong polarity
green LED does not light
green Power LED turns off
Output 1 to 5
Battery, or output connectors short circuited
green LED does not light
green Power LED turns off
OPERATION
> Connect the
xBase Multi
charger to the 230 V 50Hz mains socket.
> Make sure the power indicator (green LED) lights.
> Plug the banana pins of the charging cable into the required output (Red positive to the +pole and Black negative to the – pole of the battery).
> To increase the charging current, several outputs can be used parallel. (2 outputs 70 mA generate 140 mA).
> Check that the appropriate green LED lights to signal the charging process has begun.
> If the power indicator (green LED) goes out as soon as the battery is connected, it signals wrong polarity or short-circuit.
> To terminate charging disconnect the charger from the mains first and then remove the battery pack from the charger.
CONTENTS SUPPLIED
1 x Charger
xBase Multi
1x Operating Instructions
DISCLAIMER
Information in these operating instructions can be changed without prior notice. ANSMANN ENERGY cannot accept liability for direct, indirect,
accidental or other claims or consequential damages originated by using this charger and information given in these operating instructions.
ANSMANN ENERGY GmbH
Industriestrasse 10
D-97959 Assamstadt / Germany
e-Mail: [email protected]
www.ansmann-energy.com
Technical details subject to change without prior notice. No liability accepted for typographical errors or omissions. 01/2007
1_manual_xbase_multi_07-02.indd 5
1_manual_xbase_multi_07-02.indd 5
21.02.2007 17:13:59 Uhr
21.02.2007 17:13:59 Uhr
Prozessfarbe Schwarz
Prozessfarbe Schwarz
