Anslut 414099, Руководство по эксплуатации

Страница: 34 / 38

GB
34
the set point value (60 to 90%). When the control voltage is disconnected the fan continues to run
for the set time (2 to 30 minutes). To set the maximum air humidity limit, turn the potentiometer to
H max.
Fan with delay timer and motion detector TP starts when the motion detector is activated (range 1 to
4 metres and horizontal viewing angle 100°). When no movement is detected the fan continues to
run for the set time (2 to 30 minutes).
1.
Set the start delay by turning the potentiometer Tz clockwise for longer delay, or anticlockwise
for shorter delay.
2. Set the stop delay by turning the potentiometer T clockwise for longer delay, or anticlockwise
for shorter delay.
3. Set the set point value for the air humidity by turning the potentiometer H clockwise to
increase, or anticlockwise to decrease the threshold value for the air humidity.
WARNING:
• The timer circuit is supplied with mains voltage. Disconnect the power supply from the fan before
installation.
• Use the supplied plastic screwdriver to turn and adjust the potentiometers.
• Do not use metal objects to set the potentiometers, this could damage the circuit board.
MAINTENANCE
Maintenance should be carried out at least once every 6 months.
1.
Disconnect the power supply.
2. Remove the front cover.
3. Clean the appliance with a cloth moistened with water and a mild detergent.
4. Rinse the front grille under running water.
5. Wipe the surface dry.
6. Fit the front grille.
7. Switch on the power supply.
WARNING:
Make sure no water gets into the electrical components.
TRANSPORT AND STORAGE
• Transport the appliance in the original pack.
• Store the appliance in the orginal pack in a dry, well-ventilated area (temperature 5 - 40°C,
relative humidity max 80%).
• Keep the storage area free from dust and fumes to prevent corrosion.