Anslut 019450, Руководство по эксплуатации

Страница: 12 / 20

EN
12
ASSEMBLY
Assemble the product as shown in the figures.
FIG. 1-6
MAINTENANCE
RECYCLING
Recycle end-of-life product in accordance with
local regulations. The light source should
be removed from the lamp and recycled
separately. See description of method below.
1. Undo the nuts and screws between the
stand and floodlight by hand.
2. Cut the top corner of the floodlight
housing with a hacksaw.
FIG. 7
3. Insert a flat-tip screwdriver in the gap
between the glass and the casing and
carefully pry both parts apart. Stick
another screwdriver between the glass
and casing and carefully bend apart.
Continue along the edge round the lamp
until the glass comes loose.
FIG. 8
4. Lift off the glass to access the LED light
source.
FIG. 9
5. Remove the light source.
SYMBOLS
Read the instructions.
Approved in accordance with
the relevant directives.
Protective earthing.
The product must be discarded
if the glass front is cracked or
damaged.
Recycle discarded product
in accordance with local
regulations.
The light
source is not
replaceable.
Non-replacable
control gear.
TECHNICAL DATA
Rated voltage 230 V ~ 50 Hz
Output 2x 50 W
Luminous flux 2x 4250 lm
Colour temperature 4000 K
Colour tone Cold white
Protection rating IP65
Cord length 3 m
Size L81 x W81 x H170 cm
DESCRIPTION
Work lamp with stand that has easy-to-grip
handle. Adjustable lamp housing made of
aluminium and toughened floodlight glass.
The lamp is dustproof, protected from running
water and approved for indoor and outdoor use.