EN
9
• Remove the batteries if the product is not
going to be used for some time.
• Do not expose batteries to direct sunlight,
naked flames, high temperatures or other
extreme conditions, and do not put them
on radiators.
• Avoid getting battery fluid on the skin,
in the eyes or on mucous membrane.
On contact with battery fluid, rinse
immediately with plenty of water and
seek medical attention.
• Check that the product is switched off
after use.
SYMBOLS
Read the instructions.
Safety class III.
Approved in accordance with
the relevant directives.
Recycle end-of-life product
in accordance with local
regulations.
TECHNICAL DATA
Light
Battery
1 x 1.5 V (AAA)
Luminous flux
Approx. 1 lm
Safety class
III
Remote control
Battery
2 x 1.5 V AAA
Size
90 x 45 x 22 mm
SAFETY INSTRUCTIONS
Read these instructions carefully before use,
and save them for future reference.
These instructions should be enclosed
with the product if it is sold or passed on.
• This product can be used by children from
8 years of age and by persons with
physical, sensorial or mental disabilities,
or persons who lack experience or
knowledge, if they are supervised or
receive instructions concerning the safe
use of the product and understand the
risks involved.
• Keep children under supervision to make
sure they do not play with the product.
Do not allow children to clean or maintain
the product without supervision.
• The product is only intended for indoor use.
• Clean the outside of the product with a
damp cloth.
• The LEDs in the lights cannot be replaced.
The complete light must therefore be
discarded if there is a fault on an LED.
BATTERIES
• Only use 1.5 V batteries, size AAA.
• Do not attempt to charge non-rechargeable
batteries. Risk of explosion.
• Remove discharged batteries from the
product at once, otherwise there is a risk
of battery leakage.
• Store batteries out of the reach of children
and pets. Never short circuit, dismantle or
burn batteries.
• Seek medical attention immediately if
anyone has swallowed a battery.
• Check and if necessary clean the battery
contact surfaces on the product before
inserting the batteries.
• Insert the batteries with the correct
polarity.
