Anslut 014811, Руководство по эксплуатации

Страница: 24 / 52

EN
24
C. When the timer is activated, press the
button to check the time left or to
reset the set time. When the product is in
timer mode it is started and stopped by the
thermostat, depending on the ambient
temperature, in the same way as in normal
run mode. The timer is reset to zero if there
is a power failure.
MEMORY FUNCTION
After a power failure the product runs in
the mode that was activated before the last
standby period. The product needs to be
manually started after the power is cut.
SAFETY FUNCTIONS
If the ambient indoor temperature Th is higher
than 50°C in standby mode or run mode,
all outputs are switched off, 10 long audio
prompts are given, and the display shows FF
and flashes at 1 Hz for 75 seconds. The product
cannot be restarted when the safety function
is activated, even if the ambient temperature
drops below 50°C. Reset by switching off and
starting the product with the power switch.
After this the product can be used as usual.
SWITCHING OFF
When the product is on, press the power switch
on the control panel to put the product in
standby mode. Pull out the plug and wait until
the product has cooled. Check that the product
is stable.
MAINTENANCE
CLEANING AND MAINTENANCE
• Keep the radiator fins clean and free from
dust, which can affect the emission of
heat.
• Switch off the product, pull out the plug
and allow it to cool, and wipe off dust and
dirt with a damp cloth. Do not use
detergent or abrasive agents or utensils.
• Avoid scratching the paint, this can cause
the radiator fins to corrode.
RUN/STANDBY
Plug in the plug. The buzzer gives a long audio
prompt. Press the power switch
to start
the product in standby mode. Press the switch
again
to continue in standby mode.
MODE SETTING
Press the button to select run mode (high,
medium or low).
SETTING THE TEMPERATURE
When the product is on, press the "+" button
or "–" to set the temperature. Press and
hold "+" or "–" to change the value. If no
buttons are pressed for 5 seconds the setting is
automatically saved.
TIMED START
Press the timer button instandby mode to
set the timer. Press the "+" or "–" button to set
the time. Press and hold "+" or "–" to change
the value. The product starts after the set time.
TIMED SWITCHING OFF
When the product is on, press the timer button
to set the timer. Press the "+" or "–"
button to set the time. Press and hold "+" or
"–" to change the value. The product goes into
standby mode after the set time.
A. Possible timer settings are from 0 to
24 hours. The settings increase or
decrease by one hour each time the
button is pressed. When the value
shown is 0H, press the "–" button to
switch to 24H. When the value shown is
24H, press the "+" button to switch to
0H. The timer is deactivated when the
set value is 0H.
The timer is activated when the set
value is over 0H. Set the required time
and press
the button or , or wait 5
seconds to exit settings mode.
B. When the timer is set it can be deactivated
by putting the product in standby mode
with the power switch
.