EN
24
When the air cooler is running
1.
Press this button when
the air cooler is running.
The display starts flashing.
2.
Set the required time.
The display flashes three times to
confirm the setting.
When the air cooler is in standby
mode
1.
Press this button in standby
mode. The display starts
flashing.
2.
Set the required time.
The display flashes three times to
confirm the setting.
3.
Press the button again to set the
fan mode.
Stop timer in switched off mode
To stop the timer in switched off mode,
tap the timer button (display flashes)
and then press the timer button within
6 seconds for 2 seconds to stop the
timer.
Stop timer when the air cooler is
running
To stop the timer when the air cooler is
running, tap the timer button (display
flashes) and then immediately press
the timer button for 2 seconds to stop
the timer.
MAINTENANCE
CLEANING
1. Switch off the air cooler and pull out the
plug before cleaning.
2. Clean the plastic parts on the air cooler
with a cloth moistened with water and a
mild detergent. Wipe dry with a dry cloth.
NOTE:
• Steps to follow when cleaning are given
in the section on “using the water tank”.
• Keep the ventilation openings on the
back of the motor unit clean.
SETTINGS
1. Control panel
FIG. 9
2. Display
FIG. 10
FUNCTION OF CONTROL PANEL
Button
Function
Press to start/stop the air cooler.
Press to activate/deactivate oscillation.
Tap when the air cooler is running
to start or stop the humidification
function. Use the humidification
function for a better indoor climate in
dry and/or hot weather.
The fan has 3 modes
•
Normal (level 4, status light for
normal mode goes on).
•
Sleep mode (level 2, status light
for sleep mode goes on).
•
Natural mode (level 2, status
light for natural mode goes on).
•
Tap when the air cooler is in
standby mode to increase/
reduce the set start time.
•
Tap when the air cooler is
running to increase/reduce the
set stop time. The buttons are
used to increase/reduce the fan
speed if the timer function is not
activated.
NOTE:
In timer mode each tap increases/
reduces the set time by half an hour
when set between 0 and 3 hours,
and by 1 hour when set between 3
and 10 hours.
•
When setting the fan speed,
each tap increases/reduces the
fan speed by one step.
