Setting up Remote Sensor
l
Install batteries into the remote sensor. Press the
“
TX
”
key to trigger a transmission.
The outdoor temperature and humidity section will appear on the home unit. Always set
the first sensor to CH 1. Maximum three sensors can be registered. One sensor is
included in this package.
l
To verify transmission, press the Tx button of the remote sensor. The red LED on the
remote sensor will flash when it transmit a signal. Temperature and humidity of the
remote sensor will be updated and displayed on the remote sensor.
l
When replacing batteries for the remote sensor, remember to clear the corresponding
channel of the home unit in this way: Select the respective channel by pressing the CH
button, hold the CH button 3 seconds to clear the registration. Removing the batteries
on the home unit can also clear all settings and registrations.
C/ F SELECTION on the home unit
Hold
“
MAX/MIN
”
button 3 seconds to select C and F
WEATHER FORECAST with Storm Alert
The built-in precision pressure sensor will read the atmospheric pressure and calculate the
weather condition of the next 12 hours.
The resolution:
Sunny, Partial Sunny, Cloudy, Rainy, Stormy, Icy
OFFSETTING AIR PRESSURE FOR WEATHER FORECAST
To ensure accurate weather forecast under different altitude of your location, user should
enter the existing weather condition. The unit will memorize the existing weather condition
with the current air pressure level.
The home unit will ask you to enter the existing weather condition right after installing
batteries, please select the correct weather condition by pressing
“
MAX/MIN
“
and press
“
CLEAR
”
to enter. The home unit will try to seek for a remote sensor after the weather
condition is being entered.
After the initial setup, in case the weather forecast deviates from the existing conditions, you
can still change the weather offset in the way:
1. Hold
“
CLEAR
”
button for 3 seconds to enter the pressure offset mode. The weather icon
will flash.
2. Select the existing weather condition by pressing
“
MAX/ MIN
“
.
3. Press
“
CLEAR
“
to confirm and exit.
