AnsaldoSTS F-42, Установка, эксплуатация и обслуживание

Страница: 11 / 28

INSTALLATION
SM 5924, Rev. 1, June 2009 3-1
3 INSTALLATION
3.1 Mounting
The converter can be mounted either horizontally or vertically on 7-3/8
"
x 8
"
centers with four 3/8
"
bolts.
3.2 Electrical Connections
Electrical connections are made to a plug connector mounted on the converter. Connecting cables
should be twisted pairs to minimize pick-up between the input and output circuitry. The pinning
for the connectors is shown in Figure 3–1.
D A
C B
1
2
3
4
VIEW OF PLUG CONNECTOR
FOR -2901 UNIT
VIEW OF PLUG CONNECTOR
FOR -2904 UNIT
+60 TO +80VDC INPUT
+60 TO +80VDC INPUT
B- INPUT
B- INPUT
+32VDC, 7.5 AMP OUT
+32VDC, 7.5 AMP OUT
B- OUTPUT
B- OUTPUT
U
G
0106
.00
45.
00
Figure 3–1. Plug Connector Pinning
3.3 Calibration
The converter should be calibrated at room temperature (+77°F). Calibration rheostat R15 is
located on control board CB1. The unit must be opened to gain access to R15.
1. Place an output load of 4 amperes across the output terminals P4-C and P4-D.
2. Apply 70 VDC power to the input leads P4-A and P4-B.
3. Attach voltmeter leads across PA-C and
-
P4-D and adjust R15 for a 32V output.
The unit should be calibrated for proper output after any component or board replacement.