Anritsu NF7500 Series, Руководство по эксплуатации, Страница: 22 / 78

Chapter 3 Operation Method
3-8
3.5 Setting Flow
The respective setting flows are shown below.
The setting can be performed in orders other than the order shown below.
However, please note that the IP address of the channel can be set only
after setting the channel and that the filter can be set only after setting
the scenario.
WebGUI works with CLI (Command Line Interface) of this device.
Therefore, understanding the command specifications enables you to set
the WebGUI smoothly.
For details of the command specifications, refer to [PureFlow WS1 Traffic
Shaper NF7500 series Command Reference].
STEP 1
Set the channel.
Related CLI command
Set WebGUI.
STEP 2
Set the IP address of the
channel.
STEP 3
Configure the scenario.
STEP 4
Configure the filter and rule
list (as required).
add channel
delete channel
show channel
set ip channel
unset ip channel
show ip channel
add scenario
update scenario
delete scenario
show scenario
add filter
delete filter
show filter
add rulelist group
add rulelist entry
delete rulelist group
delete rulelist entry
show rulelist
Description
Set the channel required for the bridge operation
between desired 2 ports.
Specify 1 port each on the LAN side and WAN side
of 1 channel.
When using the traffic acceleration function, set the
IP address for the channel set in STEP 1. This
setting is not required to use the traffic shaping
function only.
Set the scenario required for the traffic control.
Set the filter criteria to classify the packet.
Set the filter for the scenario set in STEP 3.
Additionally, create the rule list with the packet
classification grouped, as required, and set the list
as a filter.