Anritsu 540 A Series, Руководство по эксплуатации, Страница: 192 / 208

Error /
Warning
Number
Type Description
Screen Display
Warning Box
Message
Remedy:
Re-enter valid data value via keypad or spinwheel.
NOTE: This is an ERROR condition. Further use of the instrument is not possible until the
condition causing the error has been corrected.
015
016 W
W No Calibration Data, Channel 1
No Calibration Data, Channel 2 n*: NO CAL
DATA
Problem:
No calibration data exists for the indicated channel.
Remedy:
Perform calibration including designated channel or change measurement type for the
channel.
017
018 W
W Calibration Data Only for Transmission, Channel 1
Calibration Data Only for Transmission, Channel 2 n*: CAL IS
TRANSMSSN
Problem:
Channel set to measure Return Loss or SWR, but the calibration data for channel is for
Transmission.
Remedy:
Perform calibration for current measurement type or change channel measurement type.
019
020 W
W Calibration Data Only for Return Loss or SWR, Channel 1
Calibration Data Only for Return Loss or SWR, Channel 2 n*: CAL IS
RET LOSS
Problem:
Channel set to measure Transmission, but the calibration data for channel is for
Return Loss or SWR.
Remedy:
Perform calibration for current measurement type or change channel measurement type.
021 W Cursor Search Failed NOT FOUND
Problem:
The last cursor search command was unable to find the requested value(s) on the current
trace.
Remedy:
Amend search targets, search type, or cursor mode. (Reminder: if Relative ModeCursor is
enabled, target values are interpreted as relative to the value at the current cursor.)
Q &KDQQHO1XPEHU
) +DUGZDUH)DXOW
2 2.LQIRUPDWLRQPHVVDJH*3,%
8 8VHU(UURUNH\ERDUGLQSXWHWF
: :DUQLQJ2QO\
7DEOH% :DUQLQJ(UURU0HVVDJHVRI
OPERATI NG WARNI NG/ERROR
DATA
M ESSAGES
B-8 541XXA OM