2 of 3
Locate one of the Seat Mounts. Position the Seat Mount on
5.
the lower end of one of the Seat Swivel/Seat Supports so that
the mounting holes in the Seat Mount align with the mounting
holes in the top plate of the Seat Swivel. Install four 5/8” long
Button Head Allen Screws through the Seat Mount and the
top plate of the Seat Swivel, add Nylock Nuts and tighten the
hardware after all four Screws are installed.
Install the remaining Seat Mounts in the same manner. The
Screw heads must be inside the swivel and the Nylock Nuts
must be outside of the Swivel for the Swivel to work properly.
Phillips Head Screw
Nylock Nut
5/16” Flat Washer
Seat Mount
Contour Seat
Place one of the Seats over one of the Seat Mounts so
6.
that all the mounting holes line up. Insert four 5/16”
Phillips Screws through the Seat mounting holes, into
corresponding holes in the Seat Mount .
Place 5/16” Flat Washers and 5/16” Nylock Nuts
7.
on the end of each Screw and tighten finger tight.
After all four Screws are installed, use the #4 Phillips
Screwdriver to hold the screw head and use the
Ratchet with 1/2” Socket to tighten the Nylock Nuts.
note:
Holding the Screw still and turning the Nylock
Nut protects the finish on the Screw and Seat from
scratching and chipping during installation.
Install the remaining Seat in the same manner.
Secure the Table Top to the Table Top Bracket using 1.25”
long 5/16”Bolts (2 on each side) with a 5/16” Washer on
each of the Bolts. Install the Bolts with the hex head outside
of the Table Top frame and Flat Washers/Nylock Nuts inside
of the Support bracket. You may have to lift the Table Top
slightly to get the holes to align.
Leave the Bolts finger tight until all the Nylock Nuts are
started, then use the 1/2” Wrench and Ratchet with 1/2”
Socket to tighten the hardware.
5/16” Bolt, 1.25” Long
5/16” Flat Washer
Nylock Nut
5/16” Flat Washer
Lift the Table Top and position it over the Table Top Bracket. Rotate the Table Top until the frame on the bottom of the Table Top
8.
matches the orientation of the Table Top Bracket. Carefully lower the Table Top down onto the Table Top Bracket.
Seat Mount
Seat Support
Move the Table to the location where it will be used.
9.
note:
This table is required to be surface mounted prior to use. Follow surface mount instructions provided with the surface mount
hardware you purchase.
After two weeks, retighten all of the hardware.
10.
