Do not drag the assembled unit across any surface.
•
This product requires only periodic cleaning with a sponge and a solution of mild detergent and water to
•
remove surface dirt. Do not clean with a solvent or petroleum based products.
Furniture must not be used other than for its intended purpose and should be inspected regularly for loose,
•
missing, or broken hardware, and general instability.
Furniture that is damaged or appears to be unstable must be removed from service and be repaired or replaced.
•
Repairs must be made using only factory authorized parts and methods.
•
wArnInG
cAre AnD
mAIntenAnce
211 No
rth Lindbergh Blvd.
St. Louis, MO 63141
tel: 888.535.5005
web:
anovafurnishings.com
10/2012
6. Install the remaining Table Top Supports in the same manner.
Flanged Nut
Flat Washer
Flat Washer
1.25” Bolt
Flanged Nut
Flat Washer
2.50” Long
Screw
Flat Washer
Cross Brace
Install Rubber Feet in
the two outside holes
Table Top
Support
Flanged Nut
Flat Washer
2.50” Long Screw
Flat Washer
7. Locate the Rubber Feet and install one
in each of the two outside holes on
the bottom of each of the Table Top
Supports.
Use the Rubber Mallet to set them if
necessary.
8. Locate the Cross Brace and position it in the center of the Table Top Supports so that the mounting holes in the Brace line up
with the mounting holes in the Supports.
Place a Flat Washer on the end of one of the 2.50” long Screws and insert the Screw through the Table Top Support mounting
hole and through the matching hole in the Cross Brace.
Fasten the Screw using a Flat
Washer and Flanged Nut. Leave the
Nut finger tight.
Repeat this for the remaining Cross
Brace mounting holes.
9. Turn the table Right side up.
10. Level the Table Top while tightening all of the hardware.
11. Move the Table to the location where it will be used.
12. After two weeks, retighten all hardware.
