Anolis ArcPixel Power CE, Руководство пользователя

Страница: 17 / 26

17
Order Mode
- the menu allows to select a method how LED modules will be assigned to the Artnet Universe.
Order Compact - All LED modules will be assigned to the Universe at the first LED output. After filling
this Universe, the rest of LED modules will be assigned to the Universe at the LED output 2.
Order Universe - LED modules output will be assigned to different Universes. LED modules on the
first LED output to the Universe set at this LED output. LED modules on the second LED output to the Universe
set at the second LED output etc.
Store Config - select this function to save all changes that have been done in the menu "Dots" .
Test Dots - use this menu item to browse throw the list of sorted LED modules.The ID of corresponding dot is
shown under the dot number. Displayed LED module blinks in white.
Update Dots - allows update of the connected LED modules after standard software updating of the ArcPixel
Power-CE (item “Software Update” in the menu "Special Setting").
Note: The update via the menu "Software Update" has to be realized before running the "Update Dots"
procedure
7.4 Personality
Use this menu to modify the ArcPixel Power-CE operating behavior.
ArtNet Universe - use the menu item to assign ArtNet universe to desired LED output.
Uni.1 - ArtNet universe for LED output 1
:
Uni.4 - ArtNet universe for LED output 4
ArtNet is a proprietary protocol for transmitting DMX512 (with RDM) over UDP/IP. Up to sixteen DMX512
universes can be accessed through one IP subnet. The Universe is a single DMX 512 frame of 512 channels.
DMX Input - this menu allows you to choose desired DMX data input:
Artnet - if this input is selected (RJ45), all LED outputs (1-4) are active.
Wired DMX - if this input is selected (3-pin XLR), only LED outputs 1-3 are active.
Display Settings - this menu allows you to change the display settings.
Display Off Timer - if this item is on the display will be swiched off 2 minutes after last pressing any
button on the control panel.
Display Lightness - select this menu item to adjust the display intensity (0-100%).
Display Contrast - select this menu item to adjust contrast of the display (0-100%).
Skip Cfg Mismatch - If this function regards behaviour of the fixture if some dots have been replaced (e.g.
due to faulty dots).
No: after switching the fixture on, the channel with the new dots will be displayed and dots check
procedure will stop.You have to manually assigned new dots.
Yes: after switching the fixture on, the dots checking procedure will run and error messages
regards replaced dots will apear (in case that some problem occured). Fixture menu is accessible.
Default setting - select this option to set fixture personalities to the default (factory) values.
7.5 Test
Single Dots - the LED modules blink one by one starting from DMX address 1 (universe 1) in the colour order
red, green, blue and white.
All Dots - all connected LED modules blink together in the colour order red, green, blue and white..
Before both test sequences, the "Search Dots" and "Sort Dots" procedures from the menu "Dots" have tu be
made.
7.6 Special settings
Software Update - using this function you can update software in the fixture via PC and USB (or serial port).
The following are required in order to update software:
- PC running Windows 95/98/2000/XP/7/8 or Linux
- DMX Software Uploader
- Flash cable RS232/DMX S/N.13050624 (if you want to use a serial port of PC)