Anolis arcpad xtreme-ce, Руководство пользователя

Страница: 26 / 38

ArcPad Xtreme-CE
26
6.4 Manual mode
Use this menu for control the fixture without connected DMX console.
PrE.C. --- Preset effects control. Select this menu to call up preset positions of the channel effects.
Man.C. --- Manual effect control. Select this menu to control all channels via buttons of the control board.
To control fixture channels.
1. Use the UP/DOWN buttons to find “ Man.C“ menu.
2. Press the ENTER button.
3. Use the UP/DOWN buttons to select desired effect (channel).
List of control channels for RGBW version:
“ rEd1” - “ rEd2” - red LEDs saturations, LED modules 1 and 2
“GrE1“ - “GrE2“ - green LEDs saturations, LED modules 1 and 2
“bLu1“ - “bLu2“ - blue LEDs saturations, LED modules 1 and 2
“Whi1“ - “Whi2“ white LEDs saturations, LED modules 1 and 2
“MACr“ - colour macros
“Stro.“ - a strobe, shutter
“dimr“ - a dimmer
List of control channels for SW version:
“U
hi1” -
“U
hi3”
–
warm white LEDs saturation, LED modules 1 and 2
“Uhi2“ - “Uhi4“- cool white/neutral white LEDs saturations, LED modules 1 and 2
“Stro.“ - a strobe, shutter
“dimr“ - a dimmer
List of control channels:
“ COL.1” - LEDs saturation-module 1
“COL.2“ - LEDs saturation-module 2
“Stro.“ - a strobe, shutter
“dimr“ - a dimmer
“F.dim” a fine dimmer
4. Press the ENTER button and use the UP/DOWN buttons to set value , press the ENTER button to confirm it.
6. 5 Test sequences
Use this menu to run demo-test sequences without an external controller, which will show you some possibilities
of using the ArcPad Xtreme.
6.6 Stand-alone setting
The fixtures on a data link are not connected to the controller but can execute pre-set programs which can be
different for every fixture. “Stand-alone operation” can be applied to the single fixture or to multiple fixtures
operating synchronously.
Synchronous operation of multiple fixtures requires that they must be connected on a data link and one of them is
set as a master (“MASt“) and the rest as the slaves (“SLA“). Up to 32 fixtures can be connected in a master/slave
chain. Only one fixture can be set as the master.
Note: Disconnect the fixtures from the DMX controller before master/slave operating, otherwise data collisions can
occur and the fixtures will not work properly. See the chapters “Stand-alone operation“ and “ Master/slave
connection“.