anko MT-600, Инструкция по эксплуатации

Страница: 14 / 36

Page 14 of 36
7 Before Use
The following steps must take place before a cleaning session is to occur.
7.1 Side Brush Installation
IMPORTANT: The side brushes need to be installed before any cleaning
takes place.
•
Ensure that the robot's power is off. Turn off the
power by flipping the power switch on the side of
the robot to “O”.
•
Gently pick up the robot and lay it with its wheels facing up.
• Position the side brushes, with the square holes pointed down, and the
brush bristles angled up. Align the square hole, on the underside of the
side brush, over the square post, located inside the hollow circle. Push
down hard until it clicks in place. It does not matter which brush goes on
which side.