7
ST
OPERATING INSTRUCTION
ON
1.
Insert the plug into the suitable wall power outlet socket after setting the
thermostat to “MIN” position and the power switch to OFF (0) position.
1)
Never use the unit in places where the floor is uneven. Make sure
there
are
nothing flammable or any easily deformable objects within
1 meter (36 inches).
2)
Do not cover the unit.
3)
The heater is suitable for operation on an A.C. electricity supply
having the same voltage as that shown on its rating label.
2.
Rotate power switch to the Max (3) position then turn thermostat knob to
the "High" setting. At this moment, the unit will begin to work. When the
temperature rises to which you are satisfied with, slowly turn the thermostat
counterclockwise until the power indicator light turns off, to keep the room
temperature constant. If you want to raise or lower the room temperature,
you can either turn the thermostat clockwise to raise the temperature or
counter clockwise to lower the temperature, or set the power switch to Low
position.
3.
After use, turn the power switch to the OFF (0) position first, then
turn the thermostat to the “MIN” position, and disconnect from
mains power outlet socket.
NOTES:
1.
The power indictor will light only when the room temperature is below
the setting value of the thermostat.
2.
The room must be insulted for best heating results.
3.
The air inlets of the control chamber must be kept ventilated. If not, the
thermostat will fail to function correctly.
CLEANING AND MAINTENANCE INSTRUCTION
NING ND
M
1.
The electric heater should be cleaned regularly to wipe out the dust on the
surface of flanges, as this may influence the radiating efficiency.
2.
Disconnect the electricity supply and allow the radiator to cool, before
wiping out the dust with a soft damp cloth. Do not use detergent or
abrasives.
3.
Do not scrape the surfaces of flanges with sharp hard tools, to avoid
surfaces getting rusty due to damage on the paint coat.
TECHNICAL DATA
TECHNICAL SPECIFICATION
Voltage: 220-240V ~50Hz
Power: 2000-2400W
