5
The cot is now ready for use in low base mode.
To adjust Mattress Base Height
Carefully stand the cot upright.
Check all Bolts are tightened
until firm.
Do not over tighten bolts. Over
tightening bolts can cause panels
to crack.
6
6
Carefully lay the cot down on the
Side Panel.
Remove the 4 x Filler Bolts and
Nuts from the lower base position
on the End Panels.
Remove 4 x 35mm / 1.4in
Mattress Base Bolts.
Loosen the bolts of one End
Panel.
Secure the Mattress Base using 4
x 35mm / 1.4in Bolts.
Tighten until firm.
Refit 4 x Filler Bolts and Nuts
to the upper Mattress Base
Mounting Holes to prevent
possible finger entrapment.
1
2
4
5
1
2
4
Carefully slide the Mattress Base
to the lower position.
Ensure the pre-assembled dowel
in the Mattress Base correctly
inserts into the pre-drilled dowel
hole in the End Panel.
3
3
5
NOTE:
Loosening the bolts
of one end panel will assist
in avoiding any scratches or
dents to your Cot whilst sliding
the mattress base down to the
lower position. If end panel
bolts are loosened during this
process, ensure they are re-
tightened after you have moved
the mattress base.
