|
45
8.3. Assemble in a cut-out
For assembling the UCDM in a cut-out the mounting-kit (08517.095-xxxx)
.
is required.
The variant corresponding to the thickness of the plate can be found in the following table:
APN
Strength
APN
Strength
08517.095-0000
12
08517.095-0007
22
08517.095-0001
13
08517.095-0008
25
08517.095-0002
14
08517.095-0009
28
08517.095-0003
15
08517.095-0100
32
08517.095-0004
16
08517.095-0101
35
08517.095-0005
18
08517.095-0102
38
08517.095-0006
19
The cut-out dimensions are shown in the following sketch.
Before inserting the UCDM into the cut-out,
please assemble the tabs from the moun-
ting kit 08517.095-xxxx, as shown.
To prevent the tabs from interfering with in-
sertion of the UCDM into the cut-out, tighten
the screws from the accessory pack (M3x8)
only slightly.
