© ANITA
MP03500EN_180831
5
2. MACHINE´S SET UP
1.
Don´t make a mistake. Please according to indicatory power supply (VOLTAGE) when
wiring.
2.
The turning direction of pulley is clockwise. (Shown as the red arrow on label). If the
turning direction is error after start. First, to turn off the motor switch, and wait about
six-seven minutes to let the motor´s pulley stop really. To change the two wires station
and turn on the switch again.
3.
When you to install the synchronizer, please make the needle bar drop 2mm from
uppermost station and then tighten the locator´s screws.
4.
Suggest needle style: CP-168 with CP*5…27-SPI (steep-head)
5.
When you install the needle, please turn the face of needle´s hollow to left is about 10
degrees, for the better effect at hook thread.
6.
(The lowest position of needle sharp): When the needle bar descent to the lowest
position, the needle sharp into shuttle´s hole is about 1-1,5mm. If the needle sharp into
shuttle´s hole is too long, it will lead to twist or disconnection thread. Please loosen the
needle bar´s fixed screw (*399) before adjustment and tighten the fixed screw after
adjustment.
2. MACHINE´S LUBRICATION
1.
Please drop some lubricant oil into every oil hole (red point). (Ex. The Mobil No.2 oil)
2.
Please at least drop some lubricant oil into every oil hole every day (per 8 hours).
3.
The revolving fricative part of shuttle´s circumference, must be poured into light lubricant oil
for keeping operation smoothly.
www.garudan.cz
