© ANITA
MP03500EN_180831
22
19. OTHER ATTENTIVE ITEMS AND SOLUTION OF BREAKDOWN
Fig. 19
The elastic sheet (628-2) in shuttle and the adjusting screw (MB030003) in bobbin case, must adjust
properly for ensuring feed thread smoothly. When the elastic sheet´s sides was worn seriously,
please change it.
Please refer the following of methods, when the thread twisted:
1.
First, turn off power.
2.
Turn the wheel counter clockwise.
3.
Make the shuttle reversal and then put off the twisted thread.
If the above methods still. Can´t pull out the twisted thread, please adopt follow methods: (1) To rise
the presser-bar lifter (514) for uplift the presser foot. (2) Loose the horn tip fixed screws
(MA050010), and take apart some parts. Pull out the twisted thread. (3) Please attention, when
assembly back, the sewing arm must have be put on the center of arc´s plate and the needle plate
must have be put in the center of the horn top groove at the same time. Please tighten the fixed
screws after assembly.
If it can´t operation when you turn on the power switch and press the press-plate. Please check
follows parts:
-
If the plug is inserted?
-
If the fuse is burn? (If it has burn, please change it and check the reason)
-
If the power rubber ring is worn seriously? (If it has worn, please change it)
-
If the adjuster is set in right station?
The tweezers are for taking out the bobbin case (shown as fig.)
www.garudan.cz
