7
TROUBLESHOOTING
MBx32 -
- No Power and No Indicator Lights - check to make sure that the DC Transformer is plugged into the
MBx32 and that the DC Transformer is plugged into a power outlet. If plugged into a surge protector
or power strip, make sure the strip is on.
- No Show is playing - Check to make sure that the HB indicator light on the MBx32 is blinking. If
HB is not blinking, please contact Animated Lighting. Check to make sure that the PLAY indicator
light is on. If it is on and you don’t see a show, please troubleshoot your LC-16 controller on the
following page. If don’t see the PLAY indicator light on, then your SD is not currectly playing a
show. Your show may be a ‘timed’ show with scheduled start and stop times. If so, wait until the time
of the show, then start the show again. If the PLAY light is off and you have not purchased a
timed show, please contact Animated Lighting.
- All 6 indicator lights are flashing together steady - Eject then reinsert the SD card
- All 6 indicator lights are snaking around in a circle then lighting one single light - this is a show
card error. Please contact Animated Lighting for a card replacement.
- Slow blinking HB light, all other indicators off - Check to make sure that the SD card isn’t locked.
Remove the card from the unit by pressing the card further into the slot. Once it clicks, the card will
pop out. Remove the card from the slot and check the small slider switch on the side of the card.
Confirm that it is in the “unlocked” position.
- No Audio - Make sure that your speakers are connected to the Audio jack on the front of the
MBx32. Check to make sure that the MP3 indicator light on the unit is on. If the indicator is on and
you do not have audio output, make sure that your speakers are turned on and that all cable connec
tions have been made. If you do not see the MP3 indicator light on, then the SD card believes that no
music should be playing at this time. If this is incorrect, please contact Animated Lighting for SD
card update.
Power reset is required for all settings changes to take affect. To reset the power, remove the power
cable, wait 2 seconds, then reinsert the power cable and allow the unit a few seconds to power up.
