GENERAL INFORMATION
3
Peripheral Descriptions
A.
Power indicator
- A red indicator LED signifies that power is connected.
B.
Audio
- Connector is 3.5mm female phono jack. Sends a normal high-Z computer
level audio signal, therefore it must be connected to a high-Z input device (ie stereo
receiver, fm transmitter, certain high-Z inputs on a mixing board). The device cannot be
directly connected to a power amplifier or other low-Z device.
C.
Indicator LEDs
(1 - 6) -
- Play - ON - Signifies a show is currently playing
- MP3 - ON - Signifies that an MP3 is currently playing
- DMX - ON - Signifies that a DMX file is currently playing
- HB - Slow flash (~1sec) - signifies “OK” working status of unit
- SD - OFF - Signifies “OK” SD card
- IP - Generally OFF -
Pulses the IP address digits at startup
D.
Port 1
- This is commonly the ACL port. Connect your standard light controllers
(LC-16) to this port.
E.
Port 2
- This is commonly the XDMX port. Connect your Pixel Driver to this port. Up to
2 pixel drivers can be connected.
F.
Terminator
- Place a jumper on these two pins if you experience “shaky” looking light
shows or light shows that appear to flicker and strobe in a way that is unintended.
G.
Ethernet Connector
- Plug your MB into your internet router for a minimum of 3
hours to automatically update the time.
H.
Power Input
- Connects to the provided 7 to 24Vdc power adapter.
Connecting power to
the MBx32 is the very last step in setting up your system.
I.
Micro USB Connector
-
Reserved USB connectivity
J.
SD Card Slot
- Insert show card here. Push card all the way into the slot until it “clicks”
and remains flush with the enclosure.
K.
SD Card Indicator
-
What does this do?
