CNC Motion Setup/Testing Utility
P/N 70000510B
4
All rights reserved. Subject to change without notice.
31-January-05
Selecting an Axis
NOTE:
Select an active axis before you select an MST command
(
F1
–
F9
). If no axis is selected, the CNC displays an
Error
message that prompts you to do so.
Use the following keypad keys to select and activate the corresponding
axes:
Activates/Deactivates X-axis
Activates/Deactivates Y-axis
Activates/Deactivates Z-axis
S
Activates/Deactivates U-Axis (if available)
S
Activates/Deactivates W-Axis (if available)
S
Activates/Deactivates Spindle Axis
The active axis is displayed in the upper-left corner of the General Status
area of the MST Screen.
Entering a Password
When you enter the MST Utility and press
Balance
(
F6
),
Signal Gain
(
F7
), or
Tuning
(
F8
), the CNC prompts for the password. Enter the
appropriate password, and press
ENTER
.
The soft key activates. If the password has been entered successfully,
the CNC will not prompt for the password again, unless you exit and
re-enter the MST Utility.
X
Y
Z
S
U
W
