CNC Motion Setup/Testing Utility
P/N 70000634A
All rights reserved. Subject to change without notice.
23-December-05
21
Table 8
lists the CanBus test results displays.
Table 8, CanBus Test Results Displays
Display CanBus
Status
Normal
Normal operation.
Calibrate
Node found and CNC is calibrating.
Warning
CNC lost a node and is actively searching for active
nodes.
Bus off
Fatal error. The bus has turned itself off due to errors.
1. Line 1 of the graphic area indicates the number of active CanBus I/O
nodes and their status.
2. Line 2 of the graphic area indicates the basic machine I/O status.
3. Line 3 of the graphic area indicates:
The address of the active node. Possible values are 0 to 5.
The number of message packets lost between the node and the
controller. This should be 0.
The number of times the node has signed on since the control
started. This should be 1 unless power was interrupted.
The node bus type. This is normally 0.
4. Line 4 indicates:
The status of the ten inputs of each node.
The status of the six outputs of each node.
The three-digit decimal value of the digital/analog converter output
for nodes configured as digital/analog.
5. Subsequent lines indicate the I/O status of any additional nodes.
Содержание 4200T CNC
Страница 1: ...www anilam com ...