Angenieux OPTIMO ULTRA COMPACT, Руководство пользователя

Страница: 12 / 18

12
TOOLS FOR ADJUSTMENT
In the below table you can find the screwdrivers and the LEMO spanner we are using in factory. You can use your proper tools but
be sure they can fit perfectly to prevent any damage on the screws head, rings or optics.
Description Type Reference
Screwdriver for all Phillips screws outer rings Phillips screwdriver VESSEL 9900 P.00-75
Screwdriver for focus engraved ring and iris gear ring Flat screwdriver BERGEON 140
Spanner for LEMO connector nut 4pins Special spanner LEMO DCH.91.101.PA
Set of flat spanners for collet nuts Special spanner -
REPLACING THE MOUNT
Please refer to the next page figure for the numbers into brackets.
- Place the Optimo Ultra Compact on the front cap
- Unscrew the rear filter sub-assembly (1) anticlockwise
- Remove the two holding screws and the electronic camera interface (3)
- Unscrew the eight screws (2) from the PL mount and remove the PL mount (4)
CAUTION: pull out the PL mount straightly to prevent from any damage of the electronic camera interface inner pins (3)
- Replace the defective PL mount with a new one
- Put back all elements in reverse order
- Check your back focus and change the thickness of the flange shims to adjust the back focus distance if necessary
6 - Ajustements