Angenieux EZ1 PACK, Руководство пользователя

Страница: 19 / 62

19
4 – REPLACEMENT OF MOUNT
The procedure described below provides the information needed to
change the camera mount of an EZ-Series lens. It is independent of the
image format of the lens (S35 or FF / Vista Vision).
Warnings:
- Carry out the change of frame in a clean and dry place.
- Pay attention to optical and mechanical elements when handling them
to avoid any degradation.
Changing the mount doesn’t require any tool. For illustrations, refer to
the FIGURE 4 at the end of the manual.
- Unscrew the mounting ring (1)
- Gently remove the mount from the rear (2)
- Position the new mount with careful orientation. The hole on the moun-
ting face must face the indexing pin (3)
- With a slight twist, check that the new mount is in place
- Screw the retaining ring of the new mount (4)
5 - CONVERSION S35
↔
FF/Vista Vision
The conversion procedure described below provides the information
needed to transform an EZ-Series S35 lens into EZ-Series FF / Vista Vi -
sion lens and vice versa. This procedure is only applicable if you have an
EZ-Series package. The rear optics S35 and FF / VistaVision are factory
set and paired with the optics. They have the same serial number. Always
use the corresponding optical blocks on the lens body.
Warnings:
- Carry out the change of the optical rear in a clean and dry place.
- Pay attention to optical and mechanical elements when handling them
to avoid any degradation.
For illustrations, refer to FIGURE 5 at the end of the manual
- Before starting the procedure, make sure that you have all the neces-
sary parts: EZ-Series lens and optical rear with the same serial number,
engraved iris ring, red focal marking ring, Phillips screwdriver, hexagon
key of 1 , 5mm.
- Position the lens vertically on your work table.
- Bring the iris to mechanical stop on the side of the smallest opening
(T22 or T32)
- Unscrew the protective caps of the rear block to be fitted
- Unscrew the mounting ring and remove the mount from the rear (1) (2)
- Using a Phillips screwdriver, unscrew the 3 retaining screws of the red
ring (3) and remove the ring (4)