-
-
-
I
I
I
N
N
N
S
S
S
T
T
T
A
A
A
L
L
L
L
L
L
A
A
A
T
T
T
I
I
I
O
O
O
N
N
N
M
M
M
A
A
A
N
N
N
U
U
U
A
A
A
L
L
L
-
-
-
29
WIRING
The connection to power supply may be carried out at the back of the appliance after
removing the protection grid. (
pict.31
)
IMPORTANT:
10kg models are equipped with a 2-mt single-phase cable without
plug. 20kg/30kg models are equipped with a 2-mt three-phase supply cable without
plug. 40kg models are equipped with a 3.5m three-phase supply cable without plug.
In models with distance condenser the cabinet and the unit (
pict.32
) must be
connected separately.
Remove the electric board panel to access the cabinet terminal board. Open the
lateral panel of the electrical board (
pict.33
) in the condenser.
PLEASE USE CERTIFIED APPROVED MATERIALS
All wiring cables are to comply with the ratings shown on the technical specifications.
Cables are to be connected to the equipotential terminal. (
pict.34
)
The grounding cable is to be directly connected to a good grounding system.
(
pict.35
)
CONNECTION TO CONDENSATE DRAIN
On certain models, a condensation discharge
φ
30mm hose
installation is necessary, "SAREL" or any similar type). The
current general and local regulations as to drains are to be
complied with.
(pict.36
)
The guarantee will cease and the Manufacturer will not be liable for any damage to appliances or
operators arising from the non-compliance with the and tamperings to any part of the appliance
(electric, thermodynamic or hydraulic plant).
Pict.31
Pict.32
Pict.33
Pict.34
Pict.35
30 – 40 kg
142 kg
72kg
Pict.36
