Angelcare AC310, Руководство пользователя

Страница: 9 / 30

2.2 - SELECT THE CRIB LEG TO SECURE THE CORD COVERS
6
5
4
3
2
1
6
5
4
3
2
1
Figure 1 Figure 2
RECOMMENDED
OR
Use the crib leg by the wall closest to the Camera
(Figure 1)
. In cases where the Camera is
across the room, use the leg closest to the Camera to position the covered wire (Figure 2) .
It is always preferable that the covered cord run along a wall.
2.3 - INSTALL THE SENSOR PAD ON THE MATTRESS SUPPORT
Sensor Pad
6
5
4
3
1
2
2
3
1)
Remove the mattress
from the crib.
2) Place the Sensor Pad –
printed side up –
on top
of the hardboard.
3) Run the connection pin,
warning label and the
first 5 cord covers down
along the backside of
the crib leg,
between
the mattress support
and the inside edge of
the crib.
IMPORTANT
If your crib does not have a stable surface for the sensor
pad, you will need to place a support under it. This
hardboard support should be at least ¼” (6 mm) thick and
should have minimum dimensions of 13” x 13” (33 cm x 33
cm). This support board must be larger than the Sensor Pad
surface area.
Hardboard
4
5
4) Bring the first 4 cord
covers down the floor,
and keep the 5th cord
cover vertically, along
the backside of the
crib leg,
(between
the mattress and the
inside edge of the
crib).
5) Remove any cord slack
to make sure no parts
of the cord are loose.
9
E
N