Installation Guide
Angel Armor Ballistic Door Panel (Level IIIA) for Dodge® Charger PURSUIT
970 235 2961 [email protected] angelarmor.com
10
Replacing the Outer Window
Weatherstrip and Completing
Installation
CONTINUED
7
Re-connect the vehicle battery.
8
Attach the Angel Armor brand label to
the interior door panel by completing the
following procedure:
a
Clean the attachment location on the
door with the supplied isopropyl
alcohol wipe.
b
Allow the door surface to dry completely.
c
Remove the backing from the brand
label.
d
Apply the brand label to the door,
pressing for at least 30 seconds to
ensure proper adhesion.
Figure 12. Attaching Angel Armor brand label
Removal or
Decommission
This section describes the
process for removing the
Ballistic Door Panel for
decommission or transfer to
another vehicle.
1
Lower the window glass completely.
2
Disconnect the vehicle battery to
avoid accidental airbag deployment.
3
Follow the procedure described in
Removing
the Outer Window Weatherstrip
, on page 7.
4
Grip the nylon folds at the top edge of the
Ballistic Door Panel.
5
Slide the panel toward the back of the
vehicle, and then up, to remove it from the
door.
NOTE:
Avoid tearing the Ballistic Door
Panel’s weatherproof cover on the “teeth”
inside of door by pushing the panel toward
the interior of the vehicle before lifting it out
of the door.
6
Follow the procedure described in
Replacing
the Outer Window Weatherstrip
, on page 9.
7
If removing the panel for transfer to another
vehicle, inspect panel after removal. Contact
Angel Armor with any concerns about wear
or damage.
INSTALLATION COMPLETE:
Your vehicle is now
equipped with advanced
ballistic protection from
Angel Armor.
