Document No. 992040. Issue 8 – 09.11.22 Page 5
3.
Manoeuvring and Handling
For safety, it is recommended that the accessory stand is moved by two people, and the
stand should only be pushed in the directions indicated in Fig.1.
When loaded with accessories, special care must be taken when manoeuvring the
accessory stand; ensure the stand is loaded correctly, as described in Section 2, and the
brakes are disengaged before moving off.
WARNING: Attempting to push the stand incorrectly, or when incorrectly
loaded, could result in instability, tipping and injury to the user.
WARNING: Extra care should be taken when traversing ramps, thresholds and
stray power cables.
4.
Using the Brakes
The brakes are located on each castor of the stand and are engaged by pressing down
on the lever until it locks with a ‘click’. To disengage the brake press the lever back into
the neutral position.
WARNING: To prevent injury to the user the castor brakes must be engaged
whilst loading and unloading accessories from the stand.
5.
Cleaning and Disinfecting
It is recommended that only CE marked cleaning products are used in the cleaning of
this device. Cleaning and Disinfection should be carried out by hand only.
Clean the accessory stand with warm water and neutral detergent and dry the surfaces
thoroughly using a soft cloth. Suitable disinfectants are: quaternary ammonium
compounds, isopropyl alcohol & chlorine bleach up to 1% (10,000 ppm). Apply
disinfectant by cloth, spray or disinfectant wipe. Following disinfection, wash off the all
surfaces with clean warm water and dry thoroughly using a soft cloth.
The product will be adversely affected and its life expectancy reduced if the following
cautions are not observed;
CAUTION:
-
Do not steam clean or jet wash any area of this device.
-
Do not soak or immerse the device.
-
Do not use concentrated bleaching disinfectant solutions, organic solvent or
abrasive powders in the cleaning or disinfection of this product.
-
Dilute all disinfectants in accordance with the manufacturer’s guidelines.
-
Disinfectant products are corrosive in nature; failure to properly wash and
dry the product surface could leave a corrosive residue which may cause
damage to the product.
6.
Product Maintenance
The accessory stand does not require servicing. However, before use, visually inspect
the stand for any loose or damaged parts and foreign bodies caught in the castors.
Every six months we recommend the stand is inspected by a competent person, i.e. an
Anetic Aid service engineer, to ensure that it is safe to use; contact Anetic Aid for
further details.
NOTE: If the accessory stand is damaged or faulty it must be taken out of use with
immediate effect and the fault reported to Anetic Aid, your authorised dealer or
maintenance department. The stand must not be used until the damage or fault has
been repaired.
