Anest Iwata DDP-160D, Инструкция по эксплуатации

Страница: 29 / 36

- 27 -
■
8. Disassembly and Assembly
•Be sure to ask our distributor or the shop which sold it to you about disassembly and
assembly.If it is not done correctly, it can cause poor performance.
•Never alter equipment.
•When replacing parts, be sure to use our genuine parts.
If not, it can cause poor performance and failure.
Disassemble according to the following procedure. Assemble according to the reverse order of
disassembling procedure.
8-1.
Pump
Job 1 Remove 4 bolts from upper section of pump
and remove adaptor upper set.
Job 2
Remove 4 bolts from lower section of
pump and remove base.
Job 3 Remove 12 bolts from lids on both sides
and remove lids.
Screw bolt with hex. hole tighten up
equally with follow torque.
Adapter upper/lower 20N
・
m
Lid 30N
・
m
Method of tightening the bolt when
attaching the lid.
①
Tighten the bolts for set the lid with
the specified torque.
At this time, do not attach the adaptor
upper and lower yet.
②
Operate the pump with air pressure of
0.5-0.7MPa for 5 minutes.
At this time, liquid is not used.
③
Tighten the bolts for set the lid with
the specified torque again.
④
Tighten the bolts for set the adaptor
upper and lower.
8-2. Air operating valve
- As small holes on front and the undersurface of
airoperating valve are exhaust holes, do not allow
paint or solvent to adhere..
If it done, it can cause failure of pump.
• When fitting parts, tighten bolts with hex.hole evenly and diagonally by turns.
• Main body and Lid should be same orientation vertically. The hole with ball stopper should be downward.
• Upper adopter and Lower adoptor are different design. Upper adoptor has a bolt inside.
排気穴
Exhaust holes
Ball stopper
Bolt with hex. hole
Bolt with hex. hole
Adapter lower
Bolt with hex. hole
Body
Adapter upper
Lid
Bolt