ANEMOI AIRPIVOT, Руководство по установке

Страница: 14 / 19

AIRPIVOT
14
5.2.2
Recommendations
To ensure correct installation and functioning of the Modbus control fan, please keep in mind following
recommendations:
1- Please strip the wire 5cm as a maximum as shown below:
2 - Communication cables cannot be wound. If it were done, they could act as an antenna. Communication
cables that are not used have to be cut and left inside the shielded tube as shown below.
3 - Please keep always a distance of at least 20cm between the power and the data cable. If both cables must
cross at some point, please ensure that they do so at a 90º angle to prevent interference.
WARNING!
Do not strip the communication cable more than 5cm.
Failure to do so may lead interferences.
Do not wind the unused communications cable. Failure to do so may lead interferences.
Maintain a minimum distance between electrical and communications wiring. Failure to do so may lead
interferences.
Avoid power zones.
Failure to do so may lead interferences.
DRIVE
BOX