Anedio D2 DAC
12
Headphone Amp Maximum
Output Voltage:
4.0 Vrms (default)
5.3 Vrms (high-gain, set with internal jumpers)
Headphone Amp Maximum
Output Power
(default setting):
530 mW into 30 ohms
260 mW into 62 ohms
53 mW into 300 ohms
Headphone Amp Maximum
Output Power
(high-gain, set with internal
jumpers):
830 mW into 30 ohms
460 mW into 62 ohms
95 mW into 300 ohms
Headphone Amp Current
Output:
250 mA peak
Headphone Amp THD+N:
0.0004%, 4Vrms into 30ohms
Headphone Amp
Intermodulation Distortion:
0.0002% @ 19KHz + 20KHz, 4Vrms into 30ohms
Headphone Amp Output
Impedance:
0.035 ohm, 20-20KHz
Headphone Jack:
1/4" TRS, gold-plated
USB Streaming Mode:
Asynchronous
USB Clocks:
Two Independent Low-Jitter Master Clocks
USB Processor:
XMOS 500 MHz real-time processor
USB Audio Operating System
Requirement:
Windows 7, Vista, XP
Apple Mac OS X
USB Audio Driver:
Thesycon driver for Windows
No driver installation for Apple OS X
Galvanic Isolation:
All digital inputs, using ultra high-speed
transformers
Power Consumption:
7 W
Dimensions (W x H x D):
9.0 x 2.8 x 10.7 inches (230 x 71 x 272 mm)
Weight:
4.6 lbs (2.1 Kg)
CE Compliance
This equipment has been found to comply with the requirements of
the EN 55022 and EN 61000-6 standards.
13
Anedio D2 DAC
Trouble Shooting
Symptoms
Remedy
No power
•
Ensure the power cord is plugged in fully.
•
Check the fuse. If blown, ensure that the outputs
are not shorted. Replace it only with 0.2A/250V
5x20mm Time-lag (slow-blo). Using an incorrect
fuse will void the warranty.
Power on but no sound
•
Ensure that the correct channel is selected.
•
Ensure that the source component is turned on.
•
Ensure that the D2 DAC is not muted, indicated
by “0” on the volume display.
•
Ensure that the power amplifier is turned on.
•
Ensure that the interconnects and cables are
plugged in fully and seated properly.
•
If the above steps do not solve the problem,
recycle power by turning off the D2 DAC, waiting
10 seconds, and turning it back on.
No sound through USB
(Ch 1)
•
Ensure that the USB cable is plugged in fully and
seated properly.
•
In your media player, ensure that “Anedio USB
Audio” is selected as the device for playback.
•
If the above steps do not solve the problem,
unplug the USB cable, wait 10 seconds, and plug
it back.
•
When plugging the USB cable into the D2
converter, be sure to apply sufficient force so that
the plug is inserted promptly without hesitation.
Hum
•
Ensure that all components are connected to a
single power strip.
•
If there is a cable TV or antenna connection,
ensure that the cable/antenna grounds are
galvanically isolated from the audio ground. This
may require inserting a ground isolator.
Diffused stereo imaging
•
Ensure that the loudspeaker phase is not
inverted.
If the problem persists, please contact Anedio via the Contact page
at www.anedio.com.
