Driver Station Assembly
The driver stations can be built either in place using a plastic sheet between the Velcro and the carpet or face down on
the floor and be stood up into place after assembly.
Build the driver stations from the field center outward
1.
Center an end plate panel on the centerline of the field. The panel is 72” wide and the edges of the center
panel should sit 36” off the marked field centerline
2.
Slide a middle upright onto each side of the center plate panel and the center poly panel. Ensure a station
overhead pipe sits between the back pins of the uprights. You may need a few people to ensure the pieces are
slide in straight. A mallet may be used to encourage the panels to slide together. Be careful not to bend the
pins.
3.
Continue sliding pieces together to create a wall 3 driver stations wide, centered on the field centerline.
4.
Once the wall is built and in line with the measured chalk lines, secure the backside with 3 anchors per driver
station.
5.
Lift and lock driver station shelves into place.
Rev 1.2 10/23/14
6
