ANDREWS COMBIfl o
57
GB
6.2.8 SPARK AND IONISATION ELECTRODES
These are located on the front of the heat exchanger.
Spark electrode
Ionisation electrode
• Carefully pull off the electrical connectors.
• Undo the two screws retaining the bracket and withdraw.
• Replacement is the reverse ensuring that the gasket seal is placed correctly and is in good condition.
6.2.9 PLATE HEAT EXCHANGER
Remove condense tube Release heat exchanger
connections (X4)
Remove screws from either side of
plate heat exchanger
• Remove the lower left hand side cover to gain better access to the heat exchanger
• Remove the condense pipework from behind the heat exchanger.
• Remove the two crosshead screws, located either side of the heat exchanger.
• Drain as much of the primary and secondary systems water as possible, to reduce water spillage.
• Release all four heat exchanger connections and slide the heat exchanger toward the rear, and remove
sideways
• Replacement is the reverse.
Содержание COMBIflo 100/300
