English
- 68 -
Installing the Batteries to the Remote
1.
Lift the cover on the back of the remote upward
gently.
2.
Install two AAA batteries. Make sure to match the +
and - ends of the batteries in the battery compartment
(observe the correct polarity.
3.
Replace the cover.
Connect Power & Antenna/Cable
IMPORTANT:
The TV set is designed to operate on
220-240V AC, 50 Hz socket. After unpacking, allow
the TV set to reach the ambient room temperature
before you connect the set to the mains. Plug the
power cable to the mains socket outlet.
Aerial or Cable
VGA
SPDIF
HD
M
I2
Coax.OUT
227528
Switching On/Off
To Switch the TV On
Connect the power cord to the 220-240V AC 50 Hz.
Switch the “
” button on the bottom right hand side
under the screen to position “|” so the TV will switch to
standby mode. Then the standby LED lights up.
To switch on the TV from standby mode either:
• Press the “ ” button,
P+ / P-
or a numeric button on
the remote control.
• Press and hold the control switch on the left hand
side of the TV.
The TV will then switch on.
Note
: If you switch on your TV via
P+ / P-
buttons on the remote
control or
P/CH+/-
on the TV set, the programme that you were
watching last will be reselected.
To Switch the TV to Standby
To switch the TV to low power stand by press the “ ”
button on the remote control or press and hold the control
switch on the left hand side of the TV.
Note
: When the TV is switched to standby mode, standby LED
can blink to indicate that features such as Standby Search, Over
Air Download or Timer is active.
To Switch the TV Off
Switch the “
” button on the bottom right hand side
under the screen to position 2 as illustrated,
, so the
TV will switch off.
To power down the TV completely, unplug the power
cord from the mains socket.
First Time Installation
When turned on for the first time, the “language
selection” menu appears. The message “
Welcome
please select your language!
” is displayed in all
language options listed alphabetically.
Press the “
” or “
” button to highlight the required
language, press
OK
button to select. “First Time
Installation” appears. Use “ ” or “ ” button to set the
required country, and press “
” button to select Search
Type. Use “ ” or “ ” to set the desired search type.
Available search types are Digital and analog, digital
only and analog only. When set, press “
” to select
Teletext Language. Use “ ” or “ ” button to set the
“Teletext Language” and select “Scan Encrypted” using
“
” or “
” button. You can set
Scan Encrypted
as
Yes
if you want to scan coded stations.
Содержание L32510FHD PVR DVD
Страница 91: ...50268353...
