background image

ALIGNMENT TABS x4

REMOVE 6 CLIPS

SEALING PLUGS

DUCT KIT INSTALLATION

90-2582

90-2583

90-2584

STEP 2

Attach the assembled duct housing to the dehumidifier using screws provided . 
Additional holes will need to be made in the cabinet where holes did not 
previously exist . To properly seal the unit, use a 5/32" bit to pre-drill 
holes and use the screws provided . If you choose to use self drilling 
screws, make sure they are no longer than 1" . To secure the 
3 screws on the left side of the duct kit (opposite the filter 
access door), a bit extension of at least 6" is required . 
After securing all screws, insert the sealing plugs provided 
into the access holes on the left hand side .

STEP 3

Install the filter access door and secure with 
the two thumb screws .

STEP 1

On each housing, bend the four alignment tabs so they are protruding out of the front of 
as shown below . These are to be used as alignment features for the 24" collar .

3

Отзывы: