6
5. Installation diagram
1. Pull the front cover off the four Velcro fixings.
2. Place the unit flat on the floor and unscrew and keep the four stud retaining screws.
3. Without damaging the rubber seal carefully separate the moulded top half of the unit from the bottom
half by pulling the casing straight forward.
4. Unscrew the four forward protruding studs and keep in a safe place.
5. Stand unit upright to separate the metal wall mounting plate from the bottom half of the casing.
Pull the casing forward leaving the rear protruding studs attached to the metal backplate.
6. Secure the metal base plate with the rear studs still attached to the wall
7. Re-assembly of the unit to the wall mounted backplate with the protruding studs is the reverse
of the removal procedure
CELL
METAL BACKPLATE
COVER
INTERCONNECTING STUDS
(Unscrew)
MOTOR ASSEMBLY
OUTLET/INLET SPIGOTS
FIXING SCREWS & PLUGS
