— 14 —
Installation
STEP 14
Connect to AC
•
Connect AC plug into a grounded AC outlet having 120V, 60Hz. Place the outlet at a maximum distance of 33-1/2” (851
mm) from where the cord exits on the hood.
•
SEE IMPORTANT INSTRUCTIONS ON THIS PAGE.
3-Pronged Plug
Ground Plug
3-Prong Receptacle
IMPORTANT:
• Observe all governing codes and ordinances.
•
It is the customer’s responsibility to contact a qualified electrical installer.
• If codes permit and a separate ground wire is used, it is recommended that a qualified electrician determine that
the ground path is adequate. A 120-Volt, 60 Hz, AC-only, fused electrical supply is required on a separate 15-amp
circuit, fused on both sides of the line.
• DO NOT ground to a gas pipe.
• Check with a qualified electrician if you are not sure that the range hood is properly grounded.
• DO NOT have a fuse in the neutral or ground circuit.
IMPORTANT: Save this Installation Guide for electrical inspector’s use.
GROUNDING INSTRUCTIONS:
• This appliance must be grounded. In the event of an electrical short-circuit, grounding reduces the risk of electric
shock by providing an escape wire for the electric current.
• This appliance is equipped with a cord having a grounding wire with a grounding plug. The plug must be plugged
into an outlet that is properly installed and grounded.
WARNING:
Improper grounding can result in a risk of electric shock.
• Consult a qualified electrician if the grounding instructions are not completely understood, or if doubt exists as to
whether the appliance is properly grounded. DO NOT use an extension cord. If the power supply cord is too short,
have a qualified electrician install an outlet near the appliance.
STEP 13
Install Chimney
•
Place chimney on top of the main housing.
•
Remove the protective coating from the upper
chimney. Carefully slide the upper chimney down
into the lower chimney.
•
Use 2 screws to fix the two chimneys together
with the lower chimney bracket, make sure upper
chimney is moving freely. (See Figure #6)
•
Screw the upper chimney to the upper mounting
bracket. (See Figure # 7)
Fig #6
Fig #7
Inner Chimney Bracket
