ANC Technology
8
Note A:
For speed up establishment of wireless mesh network, please follow steps
as below:
1. Register all the field controllers first. Then turn off all the field controllers.
2. During search time, the main controller must be in normal work status, not in any
programmable menu, ready to pick all field wireless signals.
3. Take the main controller as center, turn on field controllers which are most near
by, like in the range of 500meter or 1640feet, more or less, then all field controllers
been on start automatically looking for route to communicate with main controller.
After all this layer of controllers found route to main controller, then open second
layer of field controllers in the mesh work, so on until all 4 layers of controllers all
established wireless communication with main controller.
Note B:
All field controllers need to found wireless route through relay to
communicate with main controller, the relay route could be 1, 2, or 3 layers. Field
controllers will report route to the main controller, the main controller will save this
information and follow this route to communicate with field controllers. If the field
controllers found the route, but not success to forward this information to main
controller, then the field controller will keep do so every one minute until success.
The main controller will show XX until received that route information.
5. Power off
Push the red power switch it will turn power off.
6. System sleep
During working period, controller will check the voltage of the battery time to time.
When the backup battery voltage is less than 11 V, the controller will turn off all the
valves and pumps, then put self into sleep, waiting for the solar panel to recharge
the battery. When the battery voltage is back to 11.5 V, the controller will
automatically back to normal working status. During sleep period, if the solar panel
still can’t charge up the battery, if the backup battery voltage drops to 10 V, for
protecting the battery from over discharge, the controller will automatically turn
