ANC Technology
19
A: Push [Browse/Menu] key to begin set up sensor, push [Enter/Save] key into set
up sensor, then into [Adjust Control Level]. Then push “Enter/Save” key to begin
setup, when Dry or Wet is flashing, push “Enter” again, then the LCD will show the
current moisture level. When the moisture sensor probe is in the air, the number
should be 00%, then put the sensor probe into water slowly, the moisture value will
increase, this means the sensor is working normally. If the moisture number does
not change, either the connection to moisture sensor is bad, or the moisture sensor
may be bad. Check if the cable from the valve controller has been cut or broken.
Check the connector in the extension tube, make sure it is clean, dry and the
\retaining nut is tightened.
4.
Q
：
When using several wireless field controllers, why is there so little water
flow?
A: Possibly one of the following:
A: Check and see if the Maximum number of simultaneously irrigated zones is too
many (Check from main controller). User should adjust until there is enough water
pressure.
B: Check if the valve is jammed.
C: Check water pressure and pipe. If there is not enough water pressure, reduce the
maximum number of simultaneously irrigated zones to increase water pressure.
5.
Q
：
Main controller always shows communication failure
A
：
First make sure wireless field controller registered to main controller. Learned
“ID”, and Dry/Wet levels, all at normal operating states, and batteries are charged.
B: Check if the wireless distance is over the normal range, and if there any
obstructions in the way. Communications is line of sight. Try adjusting the position
until the failure disappears.
6
. Q
：
Wireless field controller LCD is blank, has no response from any key, main
