3
6
RECHARGEABLE BATTERIES
ProLink belt packs include three “AA” rechargeable batteries and AC gang charger. Fully charged batteries yield approximately
five hours of continuous use. Alkaline batteries can be used. Connecting the AC charger to a belt pack with alkaline batteries
installed could seriously damage the system.
CAUTION: Do not attempt to charge alkaline batteries.
Some users are required (for emergency preparedness, etc.) to leave their ProLink units plugged into the charger at all times.
For those applications we recommend replacing the batteries every 12 months.
INSTALL BATTERIES
1. Remove battery door
2. Install three “AA” NiMH batteries.
3. Replace battery compartment door.
CHARGE BATTERIES
1. Connect gang charger (included) into charging port on the bottom
of the belt packs.
2. Plug gang charger into AC outlet for minimun of five hours.
LED ON = battery charging
LED OFF = battery charged
WHAT IS PROLINK
™
?
ProLink is a digital wireless, full duplex intercom system that is easy to configure and easy to operate. You can operate the
MASTER belt pack with up to three REMOTE belt packs which are identified on the side label as R1, R2 or R3. The transmitter
and receiver operate in the license free 902-928 MHz range without the need for a base station.
DEFINITIONS AND APPLICATIONS
ProLink
- wireless duplex intercom system
ProLink Network
- requires a MASTER belt pack and includes up to three REMOTE belt packs
Channel
- A or B channel selection for different applications
BELT PACK CONTROLS
Mic Gain
– controls the microphone sensitivity. Someone with a soft voice will increase the Mic Gain.
Power Knob
also controls headset volume. The Power LED is solid green while ON and flashes green when batteries need
recharging.
A/B Channel Selection
– each member of the system must be on the same channel to hear communication
RX/TX LED
– flashes RED when transmitting and is SOLID RED on the Remote belt packs when out of range of the Master
belt pack
PTT
control – push to engage in conversation and release when done
Push to Talk
or
Always ON
slide switch for the mode of operation preferred. If you want hands free operation, select
the Always On mode. Your belt pack is live at all times.
4-PIN XLR
headset connector - use Anchor Audio headsets or any headset with a dynamic microphone.
Charging Port
for the GC-9000 gang charger – charge LED glows RED when charging and stops glowing when charge
complete.
HEADSETS
ProLink uses noise cancelling headsets with a 4-pin XLR connector. Models H-2000 (dual ear muff) and H-2000S (single ear
muff) are available. The headsets include an adjustable boom microphone.
E X A M P L E 1 - O n e n e t w o r k
E X A M P L E 2 - T w o i n d e p e n d a n t n e t w o r k s i n t h e s a m e f a c i l i t y
E X A M P L E 3 - D i r e c t o r o r c o a c h t a l k i n g a n d l i s t e n i n g b e t w e e n
t w o c h a n n e l s r e q u i r e s t h e f o l l o w i n g c o n f i g u r a t i o n
MASTER
BP-9000M
Channel A
MASTER
BP-9000M
Channel A
MASTER
BP-9000M
Channel A
MASTER
BP-9000M
Channel B
MASTER
BP-9000M
Channel B
REMOTE 1
BP-9000R
Channel A
REMOTE 1
BP-9000R
CHANNEL A
CHANNEL B
REMOTE 1
BP-9000R
Channel A
REMOTE 2
BP-9000R
Channel A
REMOTE 2
BP-9000R
Channel B
REMOTE 3
BP-9000R
Channel A
REMOTE 3
BP-9000R
Channel B
REMOTE 1
BP-9000R
Channel B
REMOTE 2
BP-9000R
Channel A
REMOTE 2
BP-9000R
Channel A
REMOTE 2
BP-9000R
Channel B
REMOTE 3
BP-9000R
Channel A
REMOTE 3
BP-9000R
Channel A
REMOTE 3
BP-9000R
Channel B
Head coach or director toggles between Channel A and B
for conversations between a two ProLink networks
This is an assigned group such as the offence coach
or lighting crew
This is an assigned group such as the defense
coach or sound crew
