Copyright © 2015 Shenzhen ANB Technology Co., Ltd. All rights reserved.
working mode.
5.3 Movement Sensor
TS100W has a built-in high sensitivity movement sensor which allows device to indicate if
the vehicle is moving or not. The movement sensitivity is decided by scanning shaking times
every second. Low shaking times was configured means with high sensitivity, high shaking times
means low sensitivity. Our experience value for passenger car is 150 as the perfect. Like if you
setup the sensitivity as 150, so if the device detected it shakes more than 150times with
continuously 3seconds, device will think it's in moving.
5.4 Virtual Odometer
Virtual odometer is used to calculate traveled distance in TS100W. When TS100W detects
vehicle is engine on, it starts counting distance using GPS signal: every second it checks current
location and calculates distance between current and previous point. It keeps adding these
intervals until next engine off. And device will report this travel distance to server. If device
receive the data receiving confirmation from server, the odometer resets to be zero and start
another calculation over again. Or if it doesn’t get a confirmation reply from server, it will save
the current ODO meter value and keep adding in next trip until it's reported successfully.
Note, that TS100W does not measure distance between coordinates, that it records using time,
distance or angle change intervals. Instead, it uses virtual points which are established every
second, and calculates distance between them.
This virtual odometer for TS100W need to activate by GPRS commands and then it will begin to
start the odometer calculation. And it also could be deactivated by GPRS commands.
5.5 Voice Functionality
TS100W has functionality to receive and make shortcuts voice calls. To enable this functionality
telephone handset with electret microphone and an audio speaker must be connected to 'Audio'
port.
TS100W device can be configured to receive any incoming calls or forbid incoming call pickup by
GPRS commands or configurator tool. And TS100W has one shortcuts call button connection
capability, which will trigger device to call one preset service Phone no. automatically and start a
voice conversation.
For voice listen-in, then device will only open one way audio channel, which allows the
monitoring person to listen-in only, and person inside the vehicle will not be able to be aware. For
those authorized user's phone No. A/B/C, they can call the device directly and devices will pickup
to put through for a voice listen-in mode. The device also allows the user to send commands via
GPRS or SMS to let the device call back to a specified cell phone in the command for voice listen.
Details about these commands please refer to the SMS command list or GPRS air traffic
