Biometra TOne
Device installation and commissioning
Version 01.21
11
Insufficient ventilation may cause the de-
vice to overheat.
Before switching on the device, make sure that the power supply corresponds to the
device setting (see section "Setting the operating voltage" p. 11).
Connect the Biometra TOne thermal cycler controller to a grounded power outlet us-
ing the power cable supplied. The cable must not be replaced by an inadequately di-
mensioned power cable.
Check the operating voltage before switching on the device!
3.4
Setting the operating voltage
WARNING
Danger of electric shock! Before commissioning the device, make sure that the voltage
selector setting on the underside of the device corresponds to the power supply in your
laboratory.
The Biometra TOne thermal cycler can be operated at 100, 115 or 230 volts. The cur-
rent setting is indicated on the voltage selector switch on the underside of the controller.
To change the operating voltage, switch off the device and unplug the power plug.
Use a coin or other round object to rotate the voltage selector switch slot and adjust
the new operating voltage.
